Filter
Top Products
Chapter 4 Installing Hardware Options
Installing DIMMs
4-14
Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide
OL-7220-02
To install a DIMM, follow these steps:
Step 1 Review the safety information in the “Safety Guidelines” section on page 2-4.
Step 2 Power off the device and peripheral devices. Disconnect the power cord, and then
disconnect all external cables. Remove the cover. (See the “Removing the Cover
and Bezel” section on page 4-1 for details.
Step 3 Touch the static-protective package that contains the DIMM to any unpainted
metal surface on the device, and then remove the DIMM from the package.
Step 4 Install the DIMM:
a. Open the retaining clip on each end of the DIMM connector. Turn the DIMM
so that the pins align correctly with the connector. (See Figure 4-6.)
Figure 4-6 Installing a DIMM
Caution To avoid breaking the retaining clips or damaging the DIMM connectors, open
and close the clips gently.
DIMM 3
DIMM 4
131349