Filter
Top Products
Chapter 3 Installing the Cisco Wide Area Application Engine
Connecting Power and Booting the System
3-14
Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide
OL-7220-02
Figure 3-12 WAE-511 and WAE-611 Back Panel Ports and Receptacles
Note Cisco WAFS and ACNS software do not support the use of a keyboard or mouse
(PS/2 or USB). However, a keyboard and mouse are supported by the BIOS for
power-on self-test (POST), and the configuration or setup utility.
Connecting Power and Booting the System
To connect power to the device, follow these steps:
Step 1 Review the information in the “Safety Warnings” section on page 2-1.
Step 2 Plug the AC power cord into the power cord receptacle at the rear of the device.
(See Figure 3-12.)
Step 3 Connect the other end of the power cord to a power source at your installation site.
Step 4 Power up all externally connected devices.
1 AC power receptacle 5 Ethernet 2 receptacle
2 Mouse connector 6 USB ports (not supported)
3 Keyboard connector 7 Video connector
4 Ethernet 1 receptacle 8 Serial connector
115773
1 2 3 4
8 7 5
6