Filter
Top Products
13
Attach the Rack-Mount Brackets—Chassis Rear-Mounted
Figure 8 Attaching the Rack-Mount Brackets to the Rear of the Chassis
Depending on how the rack-mount brackets are attached to the chassis, it either protrudes from the rack or is recessed in the
rack.
Step 1 Locate the rack-mount brackets and screws and a Number 2 Phillips screwdriver.
Step 2 Align the rack-mount bracket (1) to the side of the router and insert and tighten the screws (2). Depending on which
set of holes on the rack-mount bracket that you use, the router will either be recessed in the rack or protrude from the
rack.
Note To use the cable-management bracket with the Cisco 7401ASR router rear-mounted, you must purchase a second
rack-mount kit, attach a rack-mount bracket to the left front of the chassis, and attach the cable-management bracket
to it. See page 14 for cable-management bracket installation instructions.
Go to the “Four-Post Rack Installation” section on page 15 or the “Two-Post Rack Installation” section on page 16.
1
Rack-mount bracket
2
4 screws, 8-18 x .37 in., for use with a 19-inch rack
4 screws, 8 x .375 in., for use in a 21–23-inch rack
ENABLED
RX CELLS
RX CARRIER
RX ALARM
TX
RX
ENHANCED ATM
50532
1
2