Cisco Systems 7401 Network Router User Manual


 
16
Two-Post Rack Installation
Figure 11 Installing the Cisco 7401ASR Router in a Two-Post or Telco Rack
Note Inner clearance (the width between the inner sides of the two posts or rails), must be at least 17.3 inches (43.9 cm) The
height of the chassis is 1.72 inches (4.37 cm). Airflow through the chassis is from front to back.
Step 1 Make sure that the port adapter latch is in the locked position and the screw is tightened.
Step 2 Make sure the rack brakes are locked or the rack (1) is stabilized.
Step 3 Position the router so the front is closest to you and lift it carefully into the rack. To prevent injury, avoid any sudden
twists or moves.
Step 4 Slide the chassis into the rack, pushing it back until the brackets meet the mounting strips or posts on both sides of the
rack.
Step 5 Keeping the brackets flush against the posts or mounting strips, align the holes in the brackets (3) with the holes on the
rack or mounting strip.
Step 6 For each bracket, insert and tighten two 12-24 x 0.5-inch screws (3) to the rack.
1
Two-post or telco-type rack
3
Four 12-24 x 0.5-inch screws
2
Screw hole for cable-management bracket
57572
ENABLED
RX CELLS
RX CARRIER
RX ALARM
TX
RX
ENHANCED ATM
1
2
3