2
2-3 Fiery on a TCP/IP network with Windows NT 4.0/2000/XP/Server 2003/Server 2003
Configuring a Windows NT 4.0/2000/Server 2003 server to
communicate with the Fiery
To configure a Windows NT 4.0/2000/Server 2003 server to communicate with the
Fiery, follow these general steps. More detail is provided in subsequent sections in this
chapter and in your Microsoft documentation.
• Load the TCP/IP network protocol on the server and configure it with an IP address,
subnet mask, and gateway.
• Enter the host name of the Fiery in the host name database used by your system (see
page 2-4).
• Perform Fiery Setup.
• On the Windows NT 4.0/2000/Server 2003 server, create a printer for each Fiery print
connection, install the appropriate printer drivers, and (optionally) share the printer
on the network (see page 2-5).
• Enter the host name and remote printer name of the Fiery in the printer connection.
For more information, see page 2-18.
• If the Windows NT 4.0/2000/Server 2003 server is also a workstation, install Fiery
utilities (see the User Software Installation Guide).