Filter
Top Products
4
4-13 Network Setup options
IP Address
[127.0.0.1]
Enter the Fiery IP address for Ethernet. This IP address, unlike an IP address set auto-
matically, remains the same if you restart the Fiery. You must change the default to a
valid address for your network. For information about setting up printing with
TCP/IP, see Chapter 2.
Subnet Mask
This option lets you modify the subnet mask for printing with TCP/IP over Ethernet.
To set the subnet mask, enter one of the following values:
•
255.0.0.0 if the IP address starts with a number less than 128
•
255.255.0.0 if the IP address starts with a number from 128 through 191
•
255.255.255.0 if the IP address starts with a number greater than 191
NOTE: Confirm the subnet mask setting with your network administrator before
proceeding. In some cases, the required setting may be different from that listed.
Gateway Address
[127.0.0.1]
This option appears only if you answered No to Auto Gateway Address.
Use this option to set the gateway address for printing with TCP/IP. If your network
uses a gateway, you must change the default to a correct gateway address for
your
network.