Filter
Top Products
A-6
Cisco H.323 Signaling Interface User Guide
OL-4806-01 Rev. A14
Appendix A MML User Interface and Command Reference
MML Help
Error Messages
If an MML command does not perform, an error message is displayed. Table A-4 lists the MML error
messages and their descriptions.
.
MML Help
MML has an online help feature. The MML help command displays a list of valid system commands
and an explanation of each command’s use. To display the online help, start an MML session and type
help at the command line prompt. See the
“help” section on page A-11.
Quitting an MML Session
To quit an MML session, type quit at the prompt.
Table A-4 MML Error Messages and Descriptions
Error Message Definition Description
DENY Command denied The system recognizes the command but does not
perform the requested function.
ICNV Input command not valid The system does not recognize the MML
command.
IDNV Input data not valid An unknown parameter was entered.
IISP Input syntax error Incorrect syntax was entered.
IITA Invalid target The system cannot perform the requested
operation on the specified component, or the
component does not exist.
IPRM Input parameter missing An expected parameter was not entered.
SABT Status abort The requested operation did not complete within
the allotted time.
SNVS Component not in valid state The requested operation failed because the
component is either not configured to accept the
operation or the component is already in the
desired state.
SNSP State not supported The operation is not supported by the component.
SROF Status requested operation
failed
The requested operation failed.