Filter
Top Products
3-6
Cisco H.323 Signaling Interface User Guide
OL-4806-01 Rev. A14
Chapter 3 Provisioning the Cisco HSI
Cisco HSI Configuration
PavoRedirPresInd [0-3] The value of the Pavo redirecting number presentation indicator. (If this
parameter is not provisioned, the default is Q.931 zero—no indication.)
CliInDisplaySupported STRING If this parameter is present and set to anything other than “”, the Calling Number
is also sent in the DISPLAY IE. The NetMeeting endpoint retrieves the calling
party number from the DISPLAY IE in the H.225 setup message. To enable this
parameter, set it to “Enabled.”
T38MaxVal STRING
The T38MaxVal parameter has the following optional attributes that can be
assigned values in a specific range.
Note Values for the following attributes must be expressed in hexadecimal
format.
• MaxBit—[0x0—0xFFFFFFFF]. Specifies the maximum bit rate in units
of 100 bits per second at which a transmitter can transmit or a receiver
can receive T.38 FAX data. The default value is 0x90.
• FxMaxBuf—[0x0—0xFFFFFFFF]. Specifies the maximum buffer size
for the "t38FaxMaxBuffer" parameter for the T.38 over UDP option. The
default value is 0xc8.
• FxMaxData—[0x0—0xFFFFFFFF]. Specifies the maximum datagram
size for the "t38FaxMaxDatagram" parameter for the T.38 over UDP
option. The default value is 0x48.
T38Options STRING
This T.38 Fax parameter is assigned one of the following optional values:
• FxFillBit—[0 or 1] The default value is 0.
• FxTransMMR—[0 or 1] The default value is 0.
• FxRateTransJBIG—[0 or 1] The default value is 0.
• FXRate—[Local or Trans] The default value is Trans.
• FxUdpEC—[Red or FEC] The default value is Red.
AsymmetricHandlingSupported STRING Asymmetric Codec Treatment support is enabled if this parameter is present and
set to anything other than “”. To enable Asymmetric Codec Treatment, set this
parameter to “Enabled.”
UseConfID STRING Use this parameter to specify the precedence of extracting the Global Call ID
from the Conference ID or the GUID in the H.225 Setup message. The
provisioning of this property to a value other than “” gives precedence to the
Conference ID. For example, set it to “Enabled.” To set the precedence to the
GUID field, the crafts person can either delete the property from the config or
set it to “”.
Table 3-3 Static System Data Parameters (continued)
Parameter Type Description