Filter
Top Products
2-3
Cisco H.323 Signaling Interface User Guide
OL-4806-01 Rev. A14
Chapter 2 Installing and Configuring Cisco HSI Software
Installing the Cisco HSI
Step 5 Enter the following command:
# vi .cshrc
Step 6 Enter the vi insert mode by entering the following command:
i (enter insert mode)
Step 7 Enter the following text on the first line:
source /opt/GoldWing/currentPM/local/setup.gw.csh
Step 8 Save the file and quit vi by entering the following commands:
[Esc] (exit insert mode)
:wq (write file and quit)
Step 9 Enter the following command:
# chmod 777 .cshrc
Cisco HSI Installation Information
Gather the information listed in Table 2-2 before you begin the Cisco HSI installation. Use the Notes
column in this table to record the information. Several steps in the installation procedure require you to
provide this information. Refer to this table as you proceed through the Cisco HSI installation steps.
Table 2-2 Cisco HSI Installation Information
Required Information Notes
Base directory path Note We strongly recommend that you accept the
default base directory path.
Cisco HSI user name Default: mgcusr
Cisco HSI group name Default: mgcgrp
Gatekeeper IP address
Gatekeeper port Default: 1719
Gateway prefix
Terminal alias
Gatekeeper ID Note This ID must match the entry configured in the
gatekeeper.
E-ISUP host port Note Typically 8003, but this entry must match the
peer port setting of the IPLNK object in the
PGW 2200 configuration.
VSC1
1
name (either the DNS
2
host
name, if DNS is configured, or the IP
address of the Cisco PGW 2200
3
)
VSC1 port Note Typically 8003, but this entry must match the
peer port setting of the IPLNK object in the
PGW 2200 configuration.
Installation node ID