Filter
Top Products
Single Homed Fabric Extender vPC Configuration Example
The following example shows how to configure the single homed Fabric Extender vPC topology using the
default VRF to carry the peer-keepalive messages on switch NX-5000-1 as shown in following figure:
Figure 10: vPC Configuration Example
The following example only shows the configuration of NX-5000-1 which is connected to the Fabric
Extender NX-2000-100. You must repeat these steps on its vPC peer, NX-5000-2, which is connected to
the Fabric Extender NX-2000-101.
Note
Before You Begin
Ensure that the Cisco Nexus 2000 Series Fabric Extenders NX-2000-100 and NX-2000-101 are attached and
online.
Procedure
Step 1
Enable vPC and LACP.
NX-5000-1# configure terminal
NX-5000-1(config)# feature lacp
NX-5000-1(config)# feature vpc
Cisco Nexus 5000 Series NX-OS Interfaces Configuration Guide, Release 5.2(1)N1(1)
78-26881-OL 103
Configuring Virtual Port Channels
Single Homed Fabric Extender vPC Configuration Example