Filter
Top Products
Eth1/3 enable 100
...
This example shows how to display the CDP neighbors:
The default device ID field for CDP advertisement is the hostname and serial number, as in the example
above.
Note
switch# show cdp neighbors
Capability Codes: R - Router, T - Trans-Bridge, B - Source-Route-Bridge
S - Switch, H - Host, I - IGMP, r - Repeater,
V - VoIP-Phone, D - Remotely-Managed-Device,
s - Supports-STP-Dispute
Device ID Local Intrfce Hldtme Capability Platform Port ID
d13-dist-1 mgmt0 148 S I WS-C2960-24TC Fas0/9
n5k(FLC12080012) Eth1/5 8 S I s N5K-C5020P-BA Eth1/5
Default Physical Ethernet Settings
The following table lists the default settings for all physical Ethernet interfaces:
Default SettingParameter
Enable, 100 millisecondsDebounce
Auto (full-duplex)Duplex
ARPAEncapsulation
1500 bytesMTU
1
AccessPort Mode
Auto (10000)Speed
1
MTU cannot be changed per-physical Ethernet interface. You modify MTU by selecting maps of QoS classes.
Cisco Nexus 5000 Series NX-OS Interfaces Configuration Guide, Release 5.2(1)N1(1)
78-26881-OL 31
Configuring Layer 2 Interfaces
Default Physical Ethernet Settings