Filter
Top Products
1-20
Cisco EnergyWise Configuration Guide
OL-19806-03
Chapter 1 Managing Single Entities
Manually Managing Power
Powering the PoE Port
Beginning in privileged EXEC mode:
Configuring Port Attributes
Note The energywise activitycheck command is supported on
Catalyst 6500 switches (see the Cisco IOS Release Notes for Cisco EnergyWise, EnergyWise Phase 2 for
the specific devices)
Catalyst 4500, 3750-X, 3750-E, 3750, 3560-X, 3560-E, 3650, 2960-S and 2960 switches
Cisco EtherSwitch service modules (NME-16ES-1G, NME-16ES-1G-P, NME-X-23ES-1G,
NME-X-23ES-1G-P, NME-XD-24ES-1S-P, NME-XD-48ES-2S-P)
Cisco enhanced EtherSwitch service modules (SM-D-ES2-48, SM-D-ES3-48-P, SM-D-ES3G-48-P,
SM-ES2-16-P, SM-ES2-24, SM-ES2-24-P, SM-ES3-16-P, SM-ES3-24-P, SM-ES3G-16-P,
SM-ES3G-24-P)
Step 12
show energywise
show energywise domain
Verifies your entries.
Step 13
copy running-config startup-config (Optional) Saves your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
configure terminal Enters global configuration mode.
Step 2
interface interface-id Specifies the port or the range of ports to be configured, and
enters interface configuration mode.
Step 3
energywise level level Manually powers on the port.
• For a connected PoE end point, enter a power level of 10.
• For an non- PoE-capable end point, enter a power level from
1 to 10. The end point determines the appropriate action.
Step 4
end Returns to privileged EXEC mode.
Step 5
show energywise domain
show energywise children
Verifies your entries.
Step 6
copy running-config startup-config (Optional) Saves your entries in the configuration file.
Note The power level that you set in Step 3 is the default power
level when the switch restarts.