Cisco Systems OL-19806-03 Switch User Manual


 
3-3
Cisco EnergyWise Configuration Guide
OL-19806-03
Chapter 3 EnergyWise CLI Commands
debug energywise
debug energywise
To enable debugging of EnergyWise end points and managment stations, use the debug energywise
command in privileged EXEC mode.
debug energywise {endpoint | management}
Syntax Description
Command Default EnergyWise debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug energywise command is the same as the no debug energywise command.
When you enable debugging on a stacking-capable switch, it is enabled only on the stack master. To
enable debugging on a stack member, use the session switch-number privileged EXEC command to start
a session from the stack master. Enter the debug command on the stack-member command-line prompt.
You can also use the remote command stack-member-number LINE privileged EXEC command on the
stack master to enable debugging on a member switch before you start a session.
Related Commands
endpoint Display information about EnergyWise end points running a client or agent.
management Display information about EnergyWise management stations running power
management applications.
Release Modification
12.2(53)SE1 This command was introduced on the Catalyst 3750-E, 3750, 3560-E, 3560, and 2960
switches.
12.2(54)SG This command was introduced on Catalyst 4500 switches.
12.2(33)SXI4 This command was introduced on the Catalyst 6500 switches. See the Cisco IOS
Release Notes for Cisco EnergyWise, EnergyWise Phase 2 for the specific devices.
15.0(1)M2 This command was introduced on Cisco Integrated Service Routers Generation 2
(ISR
G2), including Cisco 3900, 2900, and 1900 ISRs.
Command Description
show energywise neighbors Displays the EnergyWise neighbor tables.