Filter
Top Products
Run ScanDisk on the drive.
The drive was inserted while
system was on or in Suspend
or Hibernation.
Shut down the computer
before inserting removing a
hard drive.
DriveLock settings
cannot be accessed
in Computer Setup.
The DriveLock settings are
accessible only when you
enter Computer Setup by
turning on (not restarting)
the computer.
Completely turn off the
computer. Turn the
computer back on, then
run Computer Setup by
pressing F10 when the
blinking cursor light
appears upper-right on the
screen.
Return to the top.
Solving Infrared Problems
Problem Possible Cause Solution
Cannot
communicate
with another
computer.
The appropriate
software is not running
on both computers.
Install the appropriate software on
the second device, start the second
device, and start the program on
both computers.
The other computer
does not have an
IrDA-compliant infrared
port.
Your Compaq computer uses the IrDA
communications protocol.
Communication between infrared
devices must use the same
communications protocol. Check the
manufacturer's instructions for
connecting with infrared devices or
try connecting with a device you
know to be IrDA-compliant.
The pathway between
the infrared ports is
obstructed, one port is
more than 30 degrees
(plus or minus 15
degrees off the center
line) from the other, or
the ports are more than
one meter apart.
Remove the obstruction, align the
infrared ports to within 30 degrees,
and position computers within 1.5
feet (about 0.5 meter) of each other.
There is an interrupt
request (IRQ) conflict.
Check for IRQ conflicts in the Device
Manager. If two devices have the
same IRQ address, reassign one of
the devices.
There is a baud rate
conflict.
Select the same baud rate for both
computers.
There is a conflict with
the # bits.
Select the same # bits setting for
both computers.
There is a stop byte
conflict.
Select the same stop byte for both
computers.