Filter
Top Products
2-12 USING YOUR COMPUTER MY PRESARIO—GETTING STARTED
Installing the Wireless Wheel Mouse
Note: Before using your wireless wheel mouse, refer to the Comfort
Guidelines on the Logitech Web site at:
logitech.com/cf/support/comfortguide.cfm
1. Remove the battery
compartment cover by
pressing the tab on the
bottom of the mouse 1 and
sliding off the cover 2.
2. Insert the two AAA alkaline
batteries 3 according to the
diagram inside the battery
compartment.
3. Turn off your computer.
4. Connect the receiver cable to
the PS/2 port 4 on the back of
your computer.
5. Turn on your computer.
6. Establish communication
between the mouse and the
receiver by pressing the
Connect button 5 on the
receiver, then pressing the
Connect button 6 under
the mouse.
Compaq/
Logitech™
Wireless Wheel
Mouse
(available on select models)
Did you know ...
The wireless wheel mouse does
not alert you when the batteries
are low. You must replace the
batteries approximately every
six months.
Tip
For optimal performance,
place the receiver at least eight
inches (twenty centimeters)
away from other electrical
devices, such as the computer,
the computer monitor, or
external storage devices.
See also ...
If your wireless wheel mouse
does not function properly after
installation, refer to the
“Troubleshooting” section in
Chapter 6 of this guide.
See also ...
For information about using
your wireless wheel mouse,
refer to the “Scroll Mouse and
Wireless Mouse” section on the
next page.