Filter
Top Products
m IMPORTANT SAFETY INSTRUCTIONS
When using this device, basic safety precautions should always be followed to reduce the risk of fire, electric shock
and injury to persons, including the following:
1. Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet
basement or near a swimming pool.
2. Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
3. Do not use this product to report a gas leak in the vicinity of the leak.
4. Always disconnect the modem cable before opening the equipment enclosure or touching an uninsulated modem
cable, jack or internal component.
5. If this product was not provided with a telephone line cord, use only No. 26 AWG or larger telecommunication line
cord in order to reduce the risk of fire.
6. Do not plug a modem or telephone cable into the Network Interface Card (NIC) receptacle.
SAVE THESE INSTRUCTIONS
Telecommunications Device Approvals
The telecommunications device in your computer is approved for connection to the telephone network in the countries
whose approval markings are indicated on the product label located on the bottom of the computer or on the modem.
Refer to the documentation included with the product to ensure the product is configured for the country in which it is
located. Selecting a country other than the one in which it is located may cause your modem to be configured in a way that
violates the telecommunication regulations/laws of that country. In addition, your modem may not function properly if the
correct country selection is not made. If when selecting a country a message appears that states that the country is not
supported, this means that the modem has not been approved for use in this country and thus should not be used.
U.S. Modem Regulatory Statements
This equipment complies with Part 68 of the FCC rules. Located on the bottom of the computer or on the modem is a label
that contains, among other information, the FCC certification number and ringer equivalence number (REN) for this
equipment. If requested, this information must be provided to the telephone company.
Applicable certification jack USOC = RJ11C. An FCC compliant telephone cord and modular plug is provided with this
equipment. This equipment is designed to be connected to the telephone network or premises wiring using a compatible
modular jack which is Part 68 Compliant. See installation instructions for details.
The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive RENs on the
telephone line may result in the devices not ringing in response to an incoming call. Typically, the sum of the RENs of all
devices connected to one line should not exceed five (5.0). To be certain of the number of devices that may be connected to
a line (as determined by the total RENs) contact the local telephone company.
If this Compaq equipment causes harm to the telephone network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. But, if advance notice is not practical, the telephone company will
notify the customer as soon as possible. Also, you will also be advised of your right to file a complaint with the FCC if you
believe it is necessary.
The telephone company may make changes to its facilities, equipment, operations or procedures that could affect the
operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make
necessary modifications to maintain uninterrupted telephone service.