Filter
Top Products
RPRINTER Setup (Pre-NetWare 4)
179
14. Press <Escape> until you are at the
PRINT SERVER CONFIGURATION
menu again.
Displays this menu.
15. Select QUEUES SERVICED BY
PRINTER.
A list of defined printers for this print
server is shown.
16. Select the printer you previously
defined and press <Enter>.
An empty queue list comes up.
17. Press <Insert>. A list of available queues displays.
18. Select the queue you want this printer
to service and press <Enter>.
Prompts you for a priority.
19. Press <Enter> to use the default. Returns to the queue list.
20. Press <Escape> until you have exited
PCONSOLE.
Takes you to the command prompt.
21. Start PSERVER. Starts the PSERVER so the Internal
Ethernet Adapter can service it as an
RPRINTER.
22. In SYS VOLUME on the file server,
change to the \LOGIN directory.
You will be at this prompt.
23. Create a directory named after the
Internal Ethernet Adapter. By default,
this will be M_
xxxxxx
where
xxxxxx
equals the last six digits of the unit’s
Ethernet address (e.g. M_000BF5)
Creates the directory.
24. Within this directory, create a file called
CONFIG and open it for editing.
A blank file displays.
Table 12. RPRINTER Setup (Pre-NetWare 4) (continued)
Step Action Result of Action