Visual Manager User Interface
4-24 StorageWorks by Compaq Network Storage Router M2402 User Guide
COMPAQ CONFIDENTIAL
Writer: Kim L. Miller File Name: e-ch4 Visual Manager User Interface.doc
Codename: Part Number: 269782-001 Last Saved On: 2/22/02 4:14 PM
NOTE: To view or change configuration settings of a specific module, select one of the
options from the menu bar on the left side of the screen or select a module or port from the
router image at the top of the screen.
To make changes, modify the setting and then click Submit.
Modules Menu tasks:
• World Wide Node Name configuration—change World Wide Node Name.
• Fibre Channel Module configuration—change Fibre Channel module settings.
• SCSI Module configuration—change SCSI module settings.
Each Modules Menu option is discussed in the following sub-sections.
World Wide Node Name Configuration
The World Wide Node (WWN) Name screen is used to change the WWN Name
settings for the router.
Figure 4-16 is an example of the World Wide Node Name screen.
These WWN settings are not normally changed.
CAUTION: Changing the WWN Name could result in duplicate names on a single
Storage Area Network (SAN). Compaq recommends using the default values for
World Wide Names.
NOTE: For Controller LUN commands to be operational, WWN naming schemes MUST be
compliant with IEEE Fibre Channel Format 1, where the left-most hexadecimal character (the
NAA field) of the WWN is '1'. Further, the sixth hexadecimal value from the right must be a
value of '0' or'1'.
NOTE: If the configuration settings are reset to the factory default, these customized WWN
settings will be overwritten.