Visual Manager User Interface
4-34 StorageWorks by Compaq Network Storage Router M2402 User Guide
COMPAQ CONFIDENTIAL
Writer: Kim L. Miller File Name: e-ch4 Visual Manager User Interface.doc
Codename: Part Number: 269782-001 Last Saved On: 2/22/02 4:14 PM
SCSI module bus settings:
• Primary Initiator ID—(default: 7) must be a unique ID.
• Alternate Initiator ID—(default: none) will be used if the primary ID is taken.
Must be a unique ID.
CAUTION: If this configuration setting is incorrectly set, processing difficulties
may occur. Before changing this setting, evaluate the need for the change and
verify the desired setting. Compaq recommends backing up the router
configuration to an external file before making changes to this setting.
• Target ID(s)—adds or removes Target IDs.
CAUTION: If this configuration setting is incorrectly set, processing difficulties
may occur. Before changing this setting, evaluate the need for the change and
verify the desired setting. Compaq recommends backing up the router
configuration to an external file before making changes to this setting.
NOTE: Target IDs must be setup prior to mapping devices on the SCSI bus.
NOTE: Do not enable Target IDs unless there is a SCSI initiator on the bus that wants to
use Fibre Channel devices. This type of configuration is known as a Target Mode
configuration.
• Discovery—toggles between Enabled and Disabled.
• Discovery Delay—is the wait time after a power-up or reboot before discovering
SCSI devices.
NOTE: Compaq recommends setting the value to at least 2 seconds to ensure all SCSI
devices complete their individual power-ups.
• Bus Reset on Boot—toggles between Enabled and Disabled.
When enabled, the router will automatically reset SCSI buses during a power up
or reboot of the router.