Filter
Top Products
96 Installing System Options
Server Module Control Panel Assembly (Service-Only Procedure)
Removing the Server Module Control Panel
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1
Turn off the server module.
If the power switch on the control panel is still operational, press the power switch to turn off the
server module. See "System Status Features" on page 10.
If the server module power switch is not operational, power down the server using its remote power-
down capability. See the
Dell Remote Access Controller/Modular Chassis User’s Guide
for information
on using the remote management features of the system
2
Remove the server module from the system chassis. See "Removing a Server Module" on page 73.
3
Open the server module. See "Opening the Server Module" on page 75.
4
Remove the two screws that secure the control panel to the server module top bracket and pull out the
control panel to remove it. See Figure 3-25.
5
Remove the control-panel cable from the server module-board connector:
a
Pull up the retaining clip on top of the connector.
b
Lift up on the control panel cable to remove it from the server module-board connector.
NOTE: The control panel cable attaches to the connector on the control panel in the same manner.