Filter
Top Products
Installing System Options 97
Figure 3-25. Removing and Installing the Server Module Control Panel Assembly
Installing the Server Module Control Panel
1
Place the new control panel under the server module top bracket and secure it with the two screws. See
Figure 3-25.
2
Route the control-panel cable under its retaining clip.
3
Connect the control-panel cable to the server module-board connector:
a
Pull up the retaining clip on top of the connector.
b
Slip the cable between the retaining clip and the connector and press down on the clip to secure
the cable.
NOTE: The cable attaches to the connector on the control panel in the same manner.
4
Close the server module. See "Closing the Server Module" on page 76.
5
Install the server module. See "Installing a Server Module" on page 74.
1 screws (2) 2 control panel cable retaining
clip
3 retaining clip
4 server module-board
connector
5 control panel cable 6 top bracket
7 control panel
7
1
6
5
4
3
2