Filter
Top Products
To allow interaction with the desktop:
• Right-click the DSM SA Data Manager service in the Services control panel and select Properties.
• In the Log On tab, select Allow service to interact with desktop and click OK.
• Restart the DSM SA Data Manager service for the change to take effect.
• Ensure that the Interactive Services Detection service is running.
When the DSM SA Data Manager service is restarted with this change, the Service Control Manager logs
the following message to the System log:
The DSM SA Data Manager service is marked as an interactive service. Enabling
the Interactive Services Detection service allows the DSM SA Data Manager
service to execute interactive applications properly for an Alert Action.
Once these changes are made, the Interactive services dialog detection dialog box is displayed by the
operating system to provide access to the interactive application interface/prompt.
BMC/iDRAC Platform Events Filter Alert Messages
The following table lists all possible Platform Event Filter (PEF) messages along with a description of each
event.
Table 13. PEF Alert Events
Event Description
Fan Probe Failure The fan is running too slow or not at all.
Voltage Probe Failure The voltage is too low for proper operation.
Battery Probe Warning The battery is operating below the recommended charge level.
Battery Probe Failure The battery has failed.
Discrete Voltage Probe Failure The voltage is too low for proper operation.
Temperature Probe Warning The temperature is approaching excessively high or low limits.
Temperature Probe Failure The temperature is either too high or too low for proper operation.
Chassis Intrusion Detected The system chassis has been opened.
Redundancy (PS or Fan)
Degraded
Redundancy for the fans and/or power supplies has been reduced.
Redundancy (PS or Fan) Lost No redundancy remains for the system's fans and/or power supplies.
Processor Warning A processor is running at less than peak performance or speed.
Processor Failure A processor has failed.
Processor Absent A processor has been removed.
PS/VRM/D2D Warning The power supply, voltage regulator module, or DC to DC converter
is pending a failure condition.
PS/VRM/D2D Failure The power supply, voltage regulator module, or DC to DC converter
has failed.
Hardware log is full or emptied Either an empty or a full hardware log requires administrator
attention.
75