Dell 900 Personal Computer User Manual


 
support.dell.com Installing Upgrades on the System Board 2-19
NOTE: The system memory value reported by the operating system is 1 or 2 MB less
than the memory installed because that memory is reserved for video functions. For
example, if the computer has 64 MB of system memory, the operating system may
report 62 or 63 MB.
Replacing the System Battery
A 3.0-V CR2032 coin-cell battery mounted in a system board socket (see Figure 2-4)
maintains system configuration, date, and time information. The battery can last sev-
eral years.
NOTE: Leave your power strip turned on when the computer is turned off to extend
battery life.
If the battery expires, the computer loses the system configuration information when-
ever it is disconnected from its electrical outlet. If you have to repeatedly reset this
information after turning on the computer, replace the battery.
To replace the system battery with another CR2032 coin-cell battery, perform the fol-
lowing steps.
CAUTION: There is a danger of a new battery exploding if it is incorrectly
installed. Replace the battery only with the same or equivalent type
recommended by the manufacturer. Discard used batteries according to the
manufacturer’s instructions.
1. Make a copy of the screens in the system setup program.
You will need a written or printed copy of the system configuration information to
restore the correct settings later. See Appendix B, System Setup Program, for
instructions.
2. Remove the computer cover according to the instructions in Removing and
Replacing the Computer Cover found earlier in this chapter.
3. Remove the riser-board bracket according to the instructions in Removing and
Replacing the Riser-Board Bracket found earlier in this chapter.
4. Remove the front bezel by slightly lifting the three bezel tabs (see Figure 2-13),
and gently pulling the bezel away from the front panel.
5. Remove the drive shelf screws, and lift the drive shelf approximately
one-half inch.
The drive shelf is attached to the chassis with two screwsone to the right of
the optical drive and one to the left of the diskette drive as you face the front of
the computer (see Figure 2-13).