Dell E6400 XFR Laptop User Manual


 
Dell
Latitude™ E6400 XFR Service Manual
Page 39
CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
1. Connect the coin-cell battery cable to the system board.
2. Insert the coin-cell battery into the computer:
If you are installing the same coin-cell battery you removed, slide the battery under the tab, then press down
to seal the tape on bottom.
If you are installing a new coin-cell battery, first remove the adhesive backing paper from the coin-cell
battery. Slide the battery under the tab, then press down to seal the tape on bottom.
1 Coin-cell battery 2 Coin-cell battery cable
3. Replace the bottom access panel (see Replacing the Bottom Access Panel
).
4. Follow the procedures in After Working on Your Computer
.
15 LED Cover
15.1 Removing the LED Cover
CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
1. Follow the procedures in Before Working on Your Computer
.
2. Remove the two M2.5 x 5-mm screws from the top of the LED cover.
3. There are 5 hooks on the bottom of the LED cover.
4. To release hook 1, gently push the LED cover from right to the left.
2
1
1
234 5