Filter
Top Products
Removing and Replacing Parts: Dell Inspiron 4100
NOTICE: The memory module must be inserted at a 45-degree angle to avoid damaging the
connector.
2. Align the notch in the memory module with the slot in the center of the socket.
3. Slide the edge connector of the module firmly into the socket at a 45- degree angle, and rotate
the module down until you hear a click. If you do not hear the click, remove the module and
reinstall it.
4. Replace the cover and tighten the two captive screws.
Mini PCI Card Assembly
You must remove the Mini PCI card before the system board can be removed.
Removing the Mini PCI Card
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and
remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an
unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the Computer" before performing the following
procedure.
1. Remove the memory module cover.
2. Disconnect the Mini PCI card from the antenna cables.
3. To release a Mini PCI card from its socket, spread apart the metal securing tabs until the card
pops up slightly.
4. Lift the Mini PCI card out of its connector.
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LA...20ok/Inspiron/4100/4100_SERVICE_MAN/remove.htm (17 of 52)6/21/2004 1:02:31 AM