Filter
Top Products
Adding and Replacing Parts 125
NOTICE: When the hard drive is not in the computer, store it in protective
antistatic packaging. See "Protecting Against Electrostatic Discharge" on
page 17.
8
Pull the hard drive cover out of the computer.
9 Remove the new drive from its packaging.
Save the original packaging for use when storing or shipping the hard
drive.
NOTICE: You cannot replace your hard drive unless you open your display
first.
10
Ensure that the display is open approximately 2.54 cm (1 in).
NOTICE: Use firm and even pressure to slide the drive into place. If you force
the hard drive into place using excessive force, you may damage the hard drive
connector.
11
Press the hard drive cover into the bay until it is fully seated in the bay.
12 Turn the computer over. Use a small screwdriver to tighten the screw.
13 Use the Operating System CD to install the operating system for your
computer (see "Reinstalling Microsoft
®
Windows
®
XP" on page 113).
14 Use the Drivers and Utilities CD to install the drivers and utilities for
your computer (see "Drivers" on page 107).