Filter
Top Products
962 Configuring Link Aggregation
Status Reporting
The status outputs of the various VPC commands are self-explanatory. Both
the configured and operational status is shown in the outputs. Additional
commands are shown below that may be useful in troubleshooting MLAG
configuration or operational issues. All of the commands below are run on the
MLAG primary switch except as noted otherwise.
MLAG-Peer-A(config)#show vpc brief
VPC admin status............................... Enabled
Keep-alive admin status........................ Enabled
VPC operational status......................... Enabled
Self role...................................... Primary
Peer role...................................... Secondary
Peer detection admin status.................... Disabled
Peer-Link details
-----------------
Interface...................................... Po1
Peer-link admin status......................... Enabled
Peer-link STP admin status..................... Disabled
Configured VLANs............................... 1,10
Egress tagged VLANs............................ 10
VPC Details
-----------
Number of VPCs configured...................... 1
Number of VPCs operational..................... 1
VPC id# 1
-----------
Interface...................................... Po2
Configured VLANs............................... 1,10
VPC interface state............................ Active
Local Members Status
----------------- ------
Gi1/0/23 Up
Peer Members Status
---------------- ------
Gi1/0/23 Up