Filter
Top Products
124 Adding and Replacing Parts
www.dell.com | support.dell.com
Display
CAUTION: Before you begin this procedure, read the safety instructions at the front of this document
(see page 11).
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching a connector on the back panel of the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin
working inside the computer.
1
Follow the procedures in "Before You Begin" (see page 103).
NOTICE: Before turning the computer over and removing the screws, ensure that the display is firmly
latched closed.
2
Turn the computer over and remove the four screws (two on each side) labeled "D" on the
bottom of the computer.
3
Turn the computer right-side up.
4
Remove the left, right, and center hinge covers (see page 121).
5
Disconnect the antenna cables (pull to separate the connectors).
screws
labeled "D" (4)