136
T
T
O
O
E
E
N
N
A
A
B
B
L
L
E
E
P
P
A
A
R
R
A
A
L
L
L
L
E
E
L
L
B
B
R
R
O
O
A
A
D
D
B
B
A
A
N
N
D
D
Before you begin, ensure that each of the access point within the network is
properly configured to connect to its individual broadband Internet account.
Then ensure that either:
x each access point is connected to an Ethernet port in the network as
illustrated above or
x the access points are interconnected by WDS or
x the access points are wired to each other.
Finally, you are ready to access the web-based configuration of each of your
access point to enable the Parallel Broadband feature. You will have to enable
all the DHCP servers in all access points before enabling Parallel Broadband.
Please note that you need to interconnect all access points
Step 1:
Under the CONFIGURATION command menu, click on Parallel Broadband.
Step 2:
Next simply select Enable and click
the Apply button to make the
changes effective.
Step 3:
Repeat this for the other access
points in your network and they will
communicate with each other and
assign each new user to the access
point that has the smallest load, so
that there is approximately the same
number of users on each access
point.
Important:
If you have only one unit of the access point, you DO NOT need
to implement the Parallel Broadband feature for broadband
Internet sharing.