Filter
Top Products
177
S
S
t
t
e
e
p
p
5
5
:
:
From the Start menu, click Run and type cmd. When the command prompt
window appears, type in the following command:
X:\recovery\TFTP -i 192.168.168.1 PUT image_name.IMG, where X refers to
your CD drive and
image_name.IMG to the firmware filename found in the
Recovery folder of the Product CD.
S
S
t
t
e
e
p
p
6
6
:
:
If you have downloaded a newer firmware and have saved it in your local
hard disk as: C:\accesspoint\accesspointxxx.IMG, then replace the
command with this new path and firmware name. In our example:
C:\accesspoint\TFTP –i 192.168.168.1 PUT accesspointxxx.img
The recovery process will now take place. You can check the diagnostic LED
to monitor the progress of the recovery process.
When firmware restoration has completed, reboot the access point and it will
be ready to operate.