Filter
Top Products
T1 Modem Bank
126
+FMFR Manufacturer’s Identification.
Command syntax: +FMFR?
Response value: The information text cannot exceed 2048 characters.
This command causes the modem to send one or more lines of information text which is used to identify the
manufacturer.
+FREV Request Product Revision Identification.
Command syntax: +FREV?
Response value: The information text cannot exceed 2048 characters.
This command causes the modem to send one or more lines of information text which is used to identify the
version, revision level or data, or other pertinent information.
+FPHCTO DTE Phase C Response Time-out.
Command syntax: +FPHCTO=<value>
value = 0 - 255 (100 ms units)
Default value: 30
This value determines how long the modem will wait for a command after reaching the end of data when
transmitting in Phase C.
+FPTS Page Transfer Status.
Command syntax: +FPTS=<ppr>
1: MCF Page good.
2: RTN Page good; retrain requested.
3: RTP Page good; retrain requested.
+FRBC Phase C Receive Data Block Size.
Command syntax: +FRBC=<value>
0: Stream mode, Phase C data is terminated by <DLE><ETX>.
+FREL Phase C Received EOL Alignment.
Command syntax: +FREL=<value>
0: Indicates that EOL patterns are aligned as received.
+FSPL Request to Poll.
Command syntax: +FSPL=<value>
0: Indicates that the DTE does not want to poll.
+FTBC Phase C Transmit Data Block Size.
Command syntax: +FTBC=<value>
0: Stream mode, Phase C data is terminated by <DLE><ETX>.