Filter
Top Products
T1 Modem Bank
46
The following describes the display panel configuration/diagnostic process:
1. Press Right Displays current node number Press Left changes node number
2. Press Right Line Card T1 Line Select Press Left selects Line Interface or Drop & Insert
3. Press Right goes to Diagnostic Test 1 (if no left press at Line Card T1 Line Select)
4. Press Right if Drop & Insert Press Left changes EQ 0.6 1.2 1.8 2.4 3.0
5. Press Right goes to Diagnostic Test 1
6. Press Right if Line Interface Press Left selects CSU Long Haul or DSX-1 Short Haul
7. Press Right if CSU Long Haul Press Left selects AMI/D4 or B8ZS/ESF
8. Press Right either AMI/D4 or B8ZS/ESF Press Left selects Jitter, EGL, LBO
9. Press Right goes to Diagnostic Test 1 (if no left press to select Jitter, EGL, LBO)
10. Press Right if Jitter Press Left selects Rx or Tx
11. Press Right go to step 8 above
12. Press Right if EGL Press Left selects 26 or 36
13. Press Right go to step 8 above
14. Press Right if LBO Press Left selects 00 75 15 22
15. Press Right go to step 8 above
By pressing <Enter> at any time, you may exit the configuration/diagnostic mode without saving any of your
changes. The POST will then resume if it had not been completed at the time you entered configuration/diagnostic
mode. If POST had been completed when you entered configuration/diagnostic mode, the download will begin when
you exit configuration/diagnostic mode.
To exit the configuration/diagnostic mode and save your changes, cycle the T1 Modem Bank’s power off, then on
again to return to the initialized state.