Filter
Top Products
T1 Modem Bank
22
Factory-Set Jumper J1
There is one jumper, J1, on the host adapter. This jumper is set in the factory and must not be changed.
Installing the ISA Host Adapter in your Computer
1. Turn off your computer’s power and remove the cover. Refer to your computer’s manual for instructions on
cover removal and option board installation and cautions.
2. Locate an available 16-bit AT slot in your computer and remove the slot plate.
3. Plug the host adapter into the ISA slot and screw the endplate to the computer chassis.
4. Replace your computer’s cover.
5. Go to “Connecting the EPC/X Host Adapter to the T1 Modem Banks” on page 25.