Filter
Top Products
Before You Use
xiii
³ Remote management accesses control
³ Telnet/SSH session for local or remote management
³ Firmware upgrades through HTTP, TFTP, or FTP
³ The boot loader contains very simple web page to allow the users to update
the run-time firmware image.
³ Configuration file backup and restore
³ SNMPv1/v2 agent with MIB-II, ADSL Line MIB
Subscription for ADSL Service
To use the IAD, you have to subscribe for ADSL service from your broadband
service provider. According to the service type you subscribe, you will get various IP
addresses:
Dynamic IP: If you apply for dial-up connection, you will be given an Internet
account with username and password. You will get a dynamic IP by dialing up to
your ISP, such as using PPPoA, PPPoE, or MER mode.
Static IP address: If you apply for full-time connectivity, you may get either one
static IP address or a range of IP addresses from your ISP. The IP address varies
according to different ADSL service provider, such as using IPoA or MER mode.
Notes and Cautions
Note and Caution in this manual are highlighted with graphics as below to indicate
important information.
Note
Contains information that corresponds to a specific topic.
Caution
Represents essential steps, actions, or messages that should not be
ignored.