Filter
Top Products
Chapter 4: Web Configuration
85
The WAN IP settings page will differ
slightly according to the protocol that
you choose. The graphic is the one
that you will see if you choose the
PPPoE mode in the previous step.
You can select Enable NAT or change
the MTU value according to your
needs.
Add Default Route:
Check this item to add a default route.
The next figure following the WAN IP
Settings in the PPPoE mode is shown
at the right. You may refer to the
Quick Setup for further information.
If you choose IP over ATM from the
Connection Type web page, you will
get a web page as the figure.
You may refer to Quick Start –
Connection Type – IPoA section for
more information.
Add Default Route:
Check this item to add a default IPoA
route.
For example, after rebooting your
wireless IAD, the default route will be
shown on the Routing Table under
Status menu, you may check it.
If you choose Bridging from the
Connection Type web page, you will
get a web page as the figure listed at
the right side.
Please refer to Quick Setup for more
information.
After configuring the WAN IP Setting
page, press Next, and then you will
see the Summary page.
Check the information displayed here.
Enable this Internet Connection:
Check the box to enable this internet
connection or uncheck it to disable
this setting. You may change this
setting by press the Modify icon
on
the Advanced – Internet Connection
Configuration page and click Next until
the summary page is displayed.