Filter
Top Products
3
Configuring a CLARiiON Boot Device
3-31
Configuring an EMC Boot Device
Connect host
<hostname>
to storage group
<storagegroupname
> (y/n)?"
Enter Y to proceed.
8. Perform a device rescan on your host, and verify the
additional device paths are present.
◆ With brief disruption of Host Connectivity (simpler procedure
using Navisphere GUI):
RR:1.Shut down the host.
9. Remove the host from the storage group.
10. Apply the change.
11. Add the host back into the storage group.
12. Restart the host.
13. Check the array connectivity status to ensure all connections
you require are active.
Configuring Additional Boot Port Name Entries in the Boot BIOS
To take advantage of the high-availability features of the HBA boot
BIOS, you must configure additional Boot Port Name entries in the
BIOS for any additional SP ports from which you want the BIOS to
attempt to boot during system startup. Depending on the failover
software installed, follow the appropriate steps:
1. Reboot the host
When the QLogic BIOS banner (shown below) appears, press
CTRL–Q.
Different HBA models may display different banners. Be sure to select
CTRL-Q for the HBA you wish to configure.
2. After Fast!UTIL loads, the display depends on whether there are
multiple QLogic HBAs installed:
• If there is only one QLogic HBA, the Fast!UTIL Options menu
appears.
QLogic Corporation
QLA2300 PCI Fibre Channel ROM BIOS Version 1.17
Copyright © Qlogic Corporation 1993-1999 All rights reserved
Press <CTRL - Q> for Fast!UTIL
www.qlogic.com
QLogic_Windows.book Page 31 Thursday, March 10, 2005 10:31 AM