Filter
Top Products
4
Configuring iSNS settings for QLA4010
4-13
Installing and Configuring the QLogic QLA4010 iSCSI HBA (TOE)
rity password. The default password is “config” but may be
changed.
When settings have been saved, SANsurfer will reset the HBA and if
target information has been discovered properly, you will see active
connections under the Target Information dialog. Also, you can few
active targets under the HBA in the left pane as shown in this dia-
gram.
SANsurfer has other features that are useful in managing your iSCSI
storage configuration. Please refer to QLogic’s SANsurfer documen-
tation for more information about these extra features.
QLogic_Windows.book Page 13 Thursday, March 10, 2005 10:31 AM