Filter
Top Products
4
Installing and Configuring the QLA4010 iSCSI HBA to boot from an EMC Storage Array
4-17
Installing and Configuring the QLogic QLA4010 iSCSI HBA (TOE)
From this point, press S to specify additional devices. You will
need to select Other and press
ENTER.
3. Insert the diskette with the QLogic driver into the diskette drive,
and press
ENTER.
4. Select the driver by pressing
ENTER. The driver loads and you are
brought back to the Additional Devices dialog.
5. If you want to specify drivers for other devices installed in your
system, do so; otherwise press ENTER at the Additional Devices
dialog to continue with Windows installation.
6. Continue the installation procedure as though you were installing
to an internal hard disk. Choose the correct boot disk for your
iSCSI HBA from the list of discovered LUNs.
Windows 2000 For detailed installation instructions on the HP ProLiant BL20p G2
and BL40p, refer to HP ProLiant BL p-Class server blades Booting Win-
dows systems from 3rd party Storage Array Network (SAN), How To,
located here:
ftp://ftp.compaq.com/pub/supportinformation/techpubs/
other/5982-3248en_rev1_us.pdf
After completing Windows installation, reinstall the QLogic driver
using the steps under Installation Procedure for Windows 2000 and Win-
dows 2003 Hosts on page 2-16.
NOTE: For Windows 2003 installations using the QLogic STORPort driver, it
will be necessary to install the latest supported Microsoft STORPort hotfix
(QFE). Refer to the EMC Support Matrix for the current hotfix version.
QLogic_Windows.book Page 17 Thursday, March 10, 2005 10:31 AM