Filter
Top Products
Unloading and Unpacking
14
3.2.1 Handling
The Liebert FS shipping package is designed to be handled using a forklift. Forklift operators must
avoid rough handling when picking up, moving and lowering it.
3.2.2 Unpacking
To reduce the possibility of shipping damage, flywheel cabinets are secured to the pallet by two
mounting brackets and two banding straps. These same two mounting brackets are used to mount the
cabinet to the floor.
Packing elements should be removed in this order to ease unpacking:
1. Cut and remove the banding straps (see Figure 8).
2. Remove hex head bolts holding mounting brackets to pallet as shown in Figure 9.
3. Remove lag bolts holding metal mounting brackets to pallet.
4. Remove mounting brackets from Liebert FS.
Figure 9 Removing lag bolts
!
CAUTION
Exhibit care when handling Liebert FS cabinet to avoid equipment damage or injury to
personnel. Failure to do so could throw off the calibration of the mechanical components
contained in the unit and possibly cause permanent damage.
!
CAUTION
The Liebert FS has sensitive electronics and mechanical components that have been
calibrated prior to shipment.
!
CAUTION
Test lift and balance the cabinet before transporting it. Maintain minimum tilt from vertical
at all times—do not exceed 15 degrees of tilt.
!
CAUTION
Sheet metal components and framework may have sharp edges.
!
CAUTION
Use care when removing banding straps and metal mounting brackets. The banding straps
are under tension and may snap violently, causing injury. Always wear proper eye and foot
protection when unpacking or installing the system.
Lag bolts
securing
Liebert FS to
shipping pallet
Metal mounting
bracket bolted to
shipping pallet