Emerson Series 600T Power Supply User Manual


 
Installation
18
Figure 15 Internal layout
NOTE
The Liebert FS is designed for front-access-only for installation and maintenance. While the
likelihood of repair is minimal, some repair procedures require side and/or rear access.
Normally, the easiest way to handle this is to disconnect the power and control wiring and roll
the unit out into an open area on its casters. While it is acceptable, under certain
circumstances, to connect the Liebert FS to its companion UPS unit through the sides of the
Liebert FS and UPS cabinets rather than through external conduit, repair access to the Liebert
FS unit will be easier to facilitate if through-cabinet wiring is not installed.
32-1/2"
(828mm)
Right Side
(panel removed )
Fan
Magnetic
Levitation
Module
Flywheel
Module
25"
(636mm)
Front
(door open)
71-1/8"
(1807mm)
Factory-Integrated
Circuit Breaker
Data
Control
Module
Versatile
Interface
Board
Inductor
Capacitor
Module
Power
Conversion
Module