Support User Manuals

Enterasys Networks 7H4385-49 Computer Hardware User Manual

Open as PDF

of 92

Completing the Installation

3-26 Installation

Completing the Installation

CompletingtheDFEmoduleinstallationdependsonifthemoduleisbeinginstalledin:

•anewDFEmodulesystem(referto“CompletingtheInstallationofaNewSystem”on

page 3‐26),or

•anestablished,operatingDFEmodulesystem(referto“CompletingtheInstallationof

aDFEModuleinanExisting

System”onpage 3‐28).

Completing the Installation of a New System

InanewsystemofDFEmodules,oneoftheinstalledDFEmoduleswillbecomethe

managementmoduleonchassispowerup,andallDFEmoduleswillautomaticallybeset

tothefactorydefaultvalues.Acompletelistofthefactorydefaultvaluesareprovidedin

Chapter3oftheEnterasys

MatrixDFE‐PlatinumSeriesConfigurationGuide.

AfterinstallingallDFE modulesintothehostchassisandmakingtheconnectionstothe

network,proceedtothefollowingFirst‐TimeLog‐InUsingaConsolePortConnection

proceduretoaccessthemodulemanagementstartupscreenfromyourPC,terminal,or

modemconnection.

First-Time Log-In Using a Console Port Connection

StarttheCommandLineInterface(CLI)fromthemodule’slocalconsoleportasfollows:

1. Connectaterminaltothelocalconsoleportasdescribedin“ConnectingtoCOMPort

forLocalManagement”onpage 3‐20.Thestartup screen,Figure 3‐12,displays.

2. Attheloginprompt,enteroneofthefollowing

defaultusernames:

– roforRead‐Onlyaccess,

– rwforRead‐Writeaccess,or

– adminforSuperUseraccess.(ThisaccesslevelallowsRead‐Writeaccesstoall

modifiableparameters,includinguseraccounts.)

3. PressENTER.

4. ThePasswordpromptdisplays.LeavethisstringblankandpressENTER.The

moduleinformationandMatrix

promptdisplaysasshowninFigure 3‐12.

Notes: This procedure applies only to initial log-in, and to logging in to a device not yet

configured with administratively-supplied user and password settings.

By default, the Matrix DFE Series device is configured with three user login accounts: ro

for Read-Only access; rw for Read-Write access; and admin for super-user access to all

modifiable parameters. The default password is set to blank (press ENTER). For

information on changing these default passwords, refer to Chapter 3

in the Enterasys

Matrix DFE-Platinum Series Configuration Guide.

previous next