Support User Manuals

Enterasys Networks 7H4385-49 Computer Hardware User Manual

Open as PDF

of 92

Completing the Installation

3-28 Installation

Completing the Installation of a DFE Module in an Existing System

InanestablishedDFEmodulesystem,

•aDFEmoduleisalreadyestablishedasthemanagementmodule,

•thepasswordshavealreadybeensetforvarioususers,

•thesystemIPaddressisset,and

•othersystemparametershavebeenset.

WhenyouinstallanewDFEmoduleintoasystemwithanexistingconfigureduser



account,thecurrentsystemsettingsinthataccountarealreadyrecognizedbythenew

DFEmoduleanditwilloperateaccordingly.

Ifyouneedtochangeanysettings,youcanconnectaterminaltothelocalconsoleportas

describedin“ConnectingtoCOMPortforLocalManagement”onpage 3

‐20toaccess

systemmanagement,oruseaTelnetconnectiontoaccesstheDFEmodulesystem

managementasdescribedinChapter3oftheEnterasysMatrixDFE‐PlatinumSeries

ConfigurationGuide.

Logging in with an Administratively-Configured User Account

Ifthedevice’sdefaultuseraccountsettingshavebeenchanged,proceedasfollows:

1. Attheloginprompt,enteryouradministratively‐assignedusernameandpress

ENTER.

2. AtthePasswordprompt,enteryourpasswordandpressENTER.

ThenoticeofauthorizationandtheMatrixpromptdisplaysasshownbackinFigure 3‐12.

The

DFE moduleisnowreadytobeconfigured.ForinformationaboutsettingtheIP

addressandconfiguringTelnetsettingsforremoteaccesstoDFEmanagement,referto

Chapter3intheEnterasysMatrixDFE‐PlatinumSeriesConfigurationGuide.TheCLI

commandsenableyoutoinitiallysetupandperformmoreinvolved

management

configurations.

TheEnterasysMatrixDFE‐PlatinumSeriesConfigurationGuideisavailableonlineat:

http://www.enterasys.com/support/manuals

Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribed

in“GettingHelp”onpage xviii.

Note: Users with Read-Write (rw) and Read-Only access can use the set password

command to change their own passwords. Administrators with Super User (su) access

can use the set system login command to create and change user accounts, and the set

password command to change any local account password. For information on the set

password and set system login commands, refer to Chapter 3 in the Enterasys Matrix

DFE-Platinum Series Configuration Guide

.

previous next