Filter
Top Products
40 VH-2402S User Interface VH-2402S
You can use the Port Trunking Configuration screen set up port trunks as
shown below:
Figure 2-29. Port Trunking Configuration
The RJ-45 ports used for each trunk must all be on the same internal
switch chip. The port groups permitted include:
Group 1 Group 2 Group 3
1,2,3,4, 5,6,7,8, 9,10,11,12,
13,14,15,16 17,18,19,20 21,22,23,24
Only two 100Mbps fiber ports can be configured as a trunk and these
must be on the same module. However, 1000Mbps fiber ports may be on
any module in the stack.
Vertical Horizon Local Management -- VH-2402S
Port Trunking Configuration
Trunk ID Status Member List
1 2 3 4
------------- ------------- ---------------- ---------------- ---------------- ----------------
-- ------------ Unit : - Unit : - Unit : - Unit : -
Port : -- Port : -- Port : -- Port : --
-- ------------ Unit : - Unit : - Unit : - Unit : -
Port : -- Port : -- Port : -- Port : --
-- ------------ Unit : - Unit : - Unit : - Unit : -
Port : -- Port : -- Port : -- Port : --
Trunk ID : 1 Trunk ID : 1 Member Unit : 1
Member Port : 1
[Show] [More]
[Enable] [Disable] [Add] [Delete]
<OK>
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter Description
Trunk ID Configure up to three trunks per switch.
Unit Specifies a switch unit in the stack (1~7).
Port Select from 2~4 ports per trunk.
[Show] Displays trunk settings, where the first trunk listed is specified by
“Sorted by Trunk ID.”
[More] Scrolls through the list of configured trunks.
[Enable] [Disable] Enables/disables the selected trunk.