Filter
Top Products
92 Setting Up Network Projection
3. Choose
Mail, then press Enter. You see the following screen:
4. Highlight
On to receive email notifications, then press Enter.
5. Enter the IP address for the SMTP server for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used: 127.x.x.x,
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
6. Enter the SMTP server’s port number. The default value is 25.
You can enter a numeric value from 1 to 65535.
7. Choose one of the
Destination Address fields, then enter the
e-mail address and the contents of the message that you will
receive when a problem or warning occurs. You can register up to
three addresses. You can enter up to 32 alphanumeric characters
for the e-mail address.
8. Select problems or warnings to be notified about by mail.
note
If a critical problem develops
with a projector which
causes it to suddenly stop
working, it may not be
possible for the projector to
send a message.
If Standby Mode is set to
Network ON in the
Extended menu, the
projector can still be
monitored even if the
projector is in standby mode
(when the power is off).