Filter
Top Products
Setting Up the Projector
25
3. Make sure the DVI/VGA
switch on the back panel is
flipped to the right, as shown.
If necessary, use the tip of a
ballpoint pen to slide it over.
4. Connect the other end of the
computer video cable to the video port on the Macintosh. If it
doesn’t fit, you may have to use the Macintosh desktop adapter
included with your projector.
To use the adapter, remove its cover as
shown and set its DIP switches according
to the resolution you want to use, such as
16-inch mode. See your Macintosh
documentation for instructions.
Replace the cover and connect the
adapter to the free end of the computer
video cable. Then plug the cable (with
the adapter) into the video port on your
Macintosh.
Computer 2 /
Component Video
Computer 1
R/Cr/Pr
B/Cb/Pb H/C Sync V SyncG/Y
DVI/VGA switch (slide to right)