Filter
Top Products
2-24 Paper Handling
Caution:
❏ When printing on multipart forms, make sure that your
software settings keep the printing entirely within the
printable area of the forms. Printing on the edge of a
multipart form can damage the print head. For information
about the printable area, see the paper specifications in
Appendix A.
❏ Load single-sheet multipart forms glued at the side of the
form only from the paper guide, not from the optional cut-
sheet feeder.
Using Envelopes
You can print on a variety of envelopes, loading them in the same
way as you load single sheets: from the paper guide or with the
optional cut-sheet feeder. For information on loading envelopes,
read this section and see “Using Single Sheets” earlier in this
chapter or Appendix A, “Loading paper from the cut-sheet
feeder.”
For LQ-680 users:
Before printing, set the paper thickness lever to the correct
position for your envelopes as described in the table on page 2-7.
For LQ-680Pro users:
Before printing, make sure the paper thickness lever is set to Auto
or the correct position for your envelopes as described in the table
on page 2-7. Then select Envelope by pressing the Tear
Off/Special Paper button.
Load envelopes face up, flap-edge first.