Filter
Top Products
Changing Printer Settings From the Printer’s Control Panel 4-9
Manual feed wait time
This sets the amount of wait time between when paper is inserted
into the paper guide and it is fed. If the paper feeds before you
can adjust its position to your satisfaction, you can increase the
wait time.
Buzzer (beeper)
The printer beeps when an error occurs. (See “Using the Error
Indicators” on page 5-2 for more information on printer errors.)
If you do not want the printer to beep when an error occurs, turn
this setting off.
Overlapping forms (LQ-680Pro only)
This setting takes effect only when the skip-over-perforation
setting is on. When overlapping-forms setting is on, the printer
lifts up the print head each time it makes a one-inch margin with
the skip-over-perforation feature. You need to turn on both the
overlapping-forms and the skip-over-perforation settings when
you use overlapping forms. This setting is available only on
LQ-680Pro.
Changing default settings
Follow the steps below to enter the default-setting mode and
change the printer’s default settings.
Note:
❏ To print the language selection and default-setting mode
instructions, you need five sheets of A4 or letter size single-sheet
paper, or five pages of continuous paper that is at least 279 mm
(11 inches) long and 210 mm (8.27 inches) wide.
❏ If you use single sheets without an optional cut-sheet feeder, you
need to feed a new sheet of paper each time the printer ejects a printed
sheet.