Filter
Top Products
Paper Handling 2-31
Adjusting the tear-off position
If your continuous paper perforation is not aligned with the tear-
off edge, you can use the micro-adjust feature to move the
perforation to the tear-off position as follows:
1. Make sure both Tear Off lights are flashing (the paper is at
the current tear-off position). You may need to press the Tear
Off button. (See “Using the Tear Off button” on page 2-15 for
more information.)
2. Hold down the Pause button for about three seconds. The
Pause light begins flashing and the printer enters the micro-
adjust mode.
3. Press the LF/FF [
] button to feed paper forward, or press the
Load/Eject [
] button to feed paper backward, until the
paper perforation is aligned with the tear-off edge.
Note:
The printer has a minimum and a maximum tear-off position. If you
try to adjust the tear-off position beyond these limits, the printer
beeps and stops moving the paper.