Filter
Top Products
7. With the printer facing you, unclip the left side of the control panel
and lift it up slightly to release it from the case (Figure F-2).
8. At each side of the front panel there is a retaining clip, as shown in
Figure F-3. One is reached through the control panel opening.
Reach behind the cable and gently press the two clips to release the
front edge of the upper case.
9. Tilt the upper case up and slip the control panel through the
opening as shown in Figure F-4, being careful not to strain the
connector linked to the control panel.
10. Lift the upper case to release the hinges at the rear edge, then lift it
away from the printer
To replace the cover, reverse steps 2 to 10.
Figure F-3.
figure F4.
Location of retaining clips
Removing the case
Choosing and Setting Up Optional Interfaces
F-5