Filter
Top Products
*CHANGE DEFAULTS
The
defaults
are the settings in effect when you turn the printer on.
Table 2-2 shows the default settings and options for the LQ-2500. If
there are any
terms
you don’t understand, consult the Glossary at the
back of this manual.
Table 2-2. Default Settings and Options
Select with
Setting
Change with
Option
INTERFACE
Parallel, Serial
*BAUD RATE
300BPS. 600BPS. 1200BPS. 2400BPS. 4800BPS.
9600BPS. 19200BPS
l
PARITY
None. Even. Odd. Ignore
AUTO LINE FEED
On. Off
SLCT-IN
VaIid. Invalid
DEFAULT MACRO
#1, #2, #3, #4
*These settings.
and
their options. are displayed only when the Serial Interface
setting IS selected.
The preset defaults
When you receive your LQ-2500, the defaults are already set for a
parallel interface. The *Print Out Settings mode lists the default
settings, as shown below.
Default setting
>INTERFACE Parallel
>BAUD RATE *9600BPS
>PARITY
*
None
>AUTO LINE FEED
Off
>SLCT-IN
Valid
>DEFAULT MACRO
#l
Note
If you change the default settings, the printer does not recognize the
new settings until you turn the power OFF then turn it back ON again.
SelecType
2-13